Need Help!- AMC DIGITAL SERVO DRIVES DX15C08

[Jevrem]

hello,
I have buy 6 amc digiflex digital servo drives. 3 of them are working, but 3 not. I canot establish a communication whit a drives via can pci card... and a led on drives flicken (red and green)... can anyone help, where is a problem??
Thanks alot,
Marko.

[daedalus]

hi, not sure if i can help, but have some of these drives on the way myself. What is the full model number on yours? just to confirm, you can communicate with the 3 good drives when using the amc drive software, but the other 3 wont talk?

[Jevrem]

Hello! i have 3 pieces and work... but tree dont... i cant establish comunication via can... and there flicken led red-green... whit first tree is all ok! and work!! do you now where is a problem?? hardwer?? It is DX15C08 (ge2 and 3)..

[daedalus]

ge2 and ge3 indicate customised versions of the drive, unfortunately i dont have any details of exactly what was customised. These may be obvious things to check, but on the jumpers on the top of the drives, are the address / baud rate / termination switches in the same place on all drives?

Also when configuring, you are connecting the can adaptor to just one drive, not networking multiple drives?

[daedalus]

oh, forgot to mention, here is the "official" fault finding guide for red light on startup. http://www.a-m-c.com/content/support/supdocs/an-009.pdf

[Jevrem]

thanks. i read more than that pdf and nothing... ewerything is seem to be fine, but my drives are death... an I have also check my good drives and tra to make tham a fault and to be led red gren bat nothing... It lock like they are death... and led flicken red-green-red-green... and nothing...