Need Help! getting/setting PID on tek6 drives - CNCzone.com-The Largest Machinist Community on the net!

		CNCzone.com-The Largest Machinist Community on the net! > Electronics > Servo Motors and Drives
Need Help!- getting/setting PID on tek6 drives

Servo Motors and Drives Discuss servo motors, drivers and other related topics here.

This forum is sponsored by:

03-16-2009, 06:25 AM

Join Date: Jan 2009

Location: Italy

Posts: 1

getting/setting PID on tek6 drives

permalink

Hi!
I bought a Multitek Slim from Cncteknix, that uses tek6 drives.

I'm trying to get and set PID values for the drives.
Each drive has a serial port connection for PID setting, but I have no idea on how to communicate with the drive.

How can I do it?

Thanks
Best regards
Marco Pastorio

« Previous Thread | Next Thread »

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is Off HTML code is Off Trackbacks are On Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Couple of questions about setting up my Viper drives	Danno	Viper Servo drives	14	09-07-2009 04:47 PM
Setting up EMC	rmacster	LinuxCNC (formerly EMC2)	5	10-17-2007 08:47 AM
setting up servo drives	planeflier	Servo Motors and Drives	17	01-07-2007 12:34 PM
Setting up VM5	dneisler	Visual Mill	6	03-12-2006 09:50 AM
Can someone help me with these motor/drives, I think the drives are dodgy?	Darc	Stepper Motors and Drives	1	07-23-2005 06:31 PM

All times are GMT -5. The time now is 05:48 AM.