| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Servo Motors and Drives Discuss servo motors, drivers and other related topics here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
12-29-2008, 05:49 PM
| |||
| |||
I got this drive and motor from Ebay. I have it all hooked up and I can comunicate with the drive with my laptop. The problem that I have is that every time I try to move the motor or just enable it I get a "over current fault". Even with the motor diconected I get the fault once the drive is enabled. I have gone through all the settings and can't get the fault to stay off. I can reset the code on the 7 segment display but the fault light stays red, then when I go to autotune or whatever the fault comes back. I am hoping someone with experience with this drive can help.  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Need Help!- Help with Parker Compumotor CA090-00602B Servo Drive | el_tony33 | Servo Motors and Drives | 7 | 01-11-2009 09:59 PM |
| Need Help!- servo drive for parker sm series motor | ihavenofish | Servo Motors and Drives | 2 | 11-10-2008 07:42 AM |
| Parker SV-M drive : limit switches? | toninlg | Servo Motors and Drives | 0 | 08-06-2008 12:11 PM |
| In the dark | scristelli | DeskCNC Controller Board | 0 | 11-02-2007 02:58 PM |
| Complicated Maths Problem!...Long Shot... | diarmaid | Hobby Discussion | 17 | 10-17-2006 03:24 AM |
| | |
Linear Mode
