Possible to drive 200W Yaskawa with 100W Servopack? - CNCzone.com-The Largest Machinist Community on the net!

cwm9 · #1 12-09-2008, 06:15 PM

I have a 200W, 200V Yaskawa servo I'd like to drive, but the 200 watt servopacks are pretty pricey. Is it possible to use a 100 volt/100 watt servopack? How badly will this effect speed/torque if it can be done?

Alternatively I may replace the servo with a stepper.

Thanks.

mactec54 · #2 12-09-2008, 06:21 PM

Hi cwm9

No you can not use a 100w drive to drive a 200w motor You can use a 200w Drive to drive a 100w motor the 200w drives are on ebay all the time & quite cheap

marcelovx23 · #3 12-27-2008, 01:49 PM

i found a yonk yard whit a lot of yakasawa servo pack please view this thread and pick some one i can buy for you and send,, alot of this are new in box..

http://www.cnczone.com/forums/showthread.php?t=68695

this is beacuse the economic situation in my country are hard and a lot of prodiction plants are closing or going to china, is more unexpensive for them put in the trash all, than put in china

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Trouble with Yaskawa Drive & Servo	curtisturner	Servo Motors and Drives	4	04-28-2011 12:57 AM
Need Help!- Yaskawa servopack	Grubma	Servo Motors and Drives	0	10-22-2008 01:54 PM
Yaskawa LX3 servopack alarm	crocnc	Servo Motors and Drives	7	09-30-2008 06:13 PM
Yaskawa Drive + Pixie 100	curtisturner	Servo Motors and Drives	2	08-07-2007 11:06 PM
problem with Yaskawa V7 drive	rebrumm	Phase Converters and VFD	4	05-22-2006 04:40 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)