| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Servo Motors and Drives Discuss servo motors, drivers and other related topics here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
11-04-2008, 05:04 PM
| |||
| |||
I have two C. STALL TORQUE 14lb/in @ 7A MAX RPM 4000 MAX VOLTAGE 100V MAX AMP 34A Servos on a knee mill in the x and y axis and i was wondering if there is anyone who could tell me if an 80 volt 20 amp servo drive would be enough to push these servos without any trouble. These servo specs confuse me. I am not as consered about speed as i am reliability and accuracy. Thanks in advance.  |
|
#2
11-04-2008, 06:28 PM
| ||||
| ||||
| They most likely will work, you will not be able to get max. rpm probably with lower voltage. You should not normally see the Max current of 34amp, as this is the max the motor will handle before demagnetization, the drive should be set for a suitable current limit. Al.
__________________ CNC, Mechatronics Integration and Machine Design. “Logic will get you from A to B. Imagination will take you everywhere.” Albert E. |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Newbie- Best MOSFET Driver and MOSFET choice for an H-Bridge Stepper Driver? | joprinz | General Electronics Discussion | 4 | 04-28-2011 03:57 AM |
| FAQ on driver ICs? | mwirth | Stepper Motors and Drives | 2 | 12-04-2007 04:17 PM |
| single axis driver and a b.o.b.,or multi-axis driver board | .xXACEXx. | Stepper Motors and Drives | 3 | 07-02-2007 11:13 PM |
| STEPPER DRIVER FAQ {Stepper/driver amp per phase match. | huios | Stepper Motors and Drives | 0 | 08-27-2006 08:43 AM |
| driver ? | morpheus | General Electronics Discussion | 4 | 06-23-2004 08:12 AM |
| | |
Linear Mode
