Newb Question

[rubikahn]

Can someone list the basic components required on a CNC servo equiped system? What is required for the electronics on a cnc system using servos?

[Torchhead]

Servo motors with matching motor drives
encoders
Power supply for motors
Controller (power supply and computer interface)
Control Software (step & dir on most drives)
PC to drive the controller
Cables, connectors


Take a look at our RouterPak 3 and 4 (or PlasPak 3 & 4 for plasma)
http://www.CandCNC.com/SolutionsMenu.htm

They have all of the electronics you need to do CNC servo.

Tom Caudle
www.CandCNC.com

[rubikahn]

Servo motors with matching motor drives
encoders
Power supply for motors
Controller (power supply and computer interface)
Control Software (step & dir on most drives)
PC to drive the controller
Cables, connectors


Take a look at our RouterPak 3 and 4 (or PlasPak 3 & 4 for plasma)
http://www.CandCNC.com/SolutionsMenu.htm

They have all of the electronics you need to do CNC servo.

Tom Caudle
www.CandCNC.com

Thank you!

[pmac]

i am using delta tau's umac for my cnc. i would like to find out how could i tune it to reduce the following error. i would like to get a maximum following error of 0.1 counts. could anyone help me eventhough you are not using the umac?..i need a rough guide on how to best tune it. anyone with expereince in maubally tuning your system pls help me...thx