| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Servo Motors and Drives Discuss servo motors, drivers and other related topics here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
12-29-2006, 09:24 PM
| |||
| |||
In my quest to gather part's for a lathe conversion and a plasma tabel I bought three off of Ebay Two are 120v two are 48V and one is 105V all are AC 3000RPM with encoder's one of the 48v seem's to have a bearing that is stiff but otherwise seem ok need help with servo drives and control ECT. any help would be greatly apreacated Thank's Kevin  |
|
#3
12-30-2006, 11:49 AM
| |||
| |||
| HillBilly I mispelled it's Actus The 120v ones are .2kw output and 1.3amp They also have nikki denso encoder's 3000rpm Square four bolt flang 2.5" with a 11mm. shaft . thought I would 2-1 belt reduce and with a 5tpi ball screw would net 300ipm at full rpm in rapid would use them for my dv59 conversion and the 48v ones are.05kw,1.2amp W8mm shaft for the plasma Would like to configure a PC based control for each Any guidence would be greatly apreaceted P.S. found this Ebay listing 330037326028 Could this be what I need Thank's Kevin Last edited by Kevin Taylor; 12-30-2006 at 09:42 PM. Reason: Ad to it |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
| | |
Linear Mode
