Help for CMC MDCX16012 DC servo amp. information

[microliang]

I had brought a Cleveland Motion Controls, Inc. (CMC) MDCX16012 DC
Brush Servo Amp.at a surplus store. But NO enough Information for this unit
even at the CMC website www.cmccontrol.com.
The MDCX16012 is brush type servo amp. But the datasheet at CMC Website
is obvious a brushless type (3 hall sensor signal pins and u,v,w motor
connector).Did anyone ever use this one? Could you help me with connector pin
defination and user manual? Or does any one know how to connect this MDCX16012 to Pixie?

The photo of this unit is at
http://www.geocities.com/microresear...C/DSCF0062.JPG
http://www.geocities.com/microresear...C/DSCF0063.JPG
http://www.geocities.com/microresear...C/DSCF0064.JPG
http://www.geocities.com/microresear...C/DSCF0065.JPG

Thanks a lot

Mic

[Al_The_Man]

Well there is this on the CMC web site
http://www.cmccontrols.com/downloads...s_mdc_mdcx.pdf
A BLDC drive can be used on a brushed motor if you can set the commutation angle to 60° and then use the U&V motor connections, and no connection to the hall inputs.
Al.

[microliang]

Thanks to Al_The_Man!
This is a little strange. They claimed the MDCX16012 is a brushed motor amp, but used BLDC connector in a brushed motor amp. CMC has ACS 1300 Brushless Servo Amplifier and MBL / MBLX Brushless Servo Amplifier.
Is there any more information ?

[Al_The_Man]

This is a little strange. They claimed the MDCX16012 is a brushed motor amp, but used BLDC connector in a brushed motor amp.

Yeah, I found that a little strange also.
Al.