| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Servo Motors and Drives Discuss servo motors, drivers and other related topics here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#2
 
05-02-2006, 10:15 PM
| ||||
| ||||
| most of the hdd motors i've seen have 4 wires. None can be run by dc current. Lots of info here http://www.epanorama.net/circuits/diskstepper.html
__________________ --- router finally being built! y axis done! hobbycnc controller done! ...mounting nsk rails and thk rail. aligning leadscrews  |
|
#3
05-02-2006, 10:36 PM
| |||
| |||
| Hard drive motors are of a brushless design. Check these guys out for more information on them http://www.gobrushless.com/ccp51/cgi-bin/cp-app.cgi
__________________ If it's not nailed down, it's mine. If I can pry it loose, it's not nailed down. |
|
#4
05-02-2006, 11:45 PM
| ||||
| ||||
| |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
| | |
Linear Mode
