LinkBack URL
About LinkBacks
www.cadcamcadcam.com has some small ones for $99 each. But, they might be smaller than you want. Camtronics has 430oz peak for $169 each http://www.camtronics-cnc.com/
Not sure what you inexpensive means to you, but Ebay may be your best bet.
| | |
I'm building a small table and I'm a newbie. But I think I want to go servo. My other table has steppers. Who has a inexpensive servo setup for small 2x3 table that is good.
Thanks
What about G320 servo Amps $114 each.
Last edited by Ed Williams; 04-15-2006 at 03:09 PM.
www.cadcamcadcam.com has some small ones for $99 each. But, they might be smaller than you want. Camtronics has 430oz peak for $169 each http://www.camtronics-cnc.com/
Not sure what you inexpensive means to you, but Ebay may be your best bet.
Gerry
Mach3 2010 Screenset
http://home.comcast.net/~cncwoodworker/2010.html
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
I don't think "inexpensive" and "servo" can be used in the same sentence.
What I'm asking is what is the best deal for a small table setup.
Thanks
WOW Camtronics has some awsome prices on brush motors with encoders.... wish I had known about this sooner!
hi
other than these two suppliers " www.cadcamcadcam.com has some small ones for $99 each. But, they might be smaller than you want. Camtronics has 430oz peak for $169 each http://www.camtronics-cnc.com/"
who else has lager servo motors for sale ate a reasonable price where you don't have to sell you house and soul
cheers
Our servo drivers are $65 each, not $99. They are plenty good for a 2 x 3 foot table.Originally Posted by ger21
Fred Smith - IMService
http://www.cadcamcadcam.com/hobby
Posting Permissions
| | |
