| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Servo Motors and Drives Discuss servo motors, drivers and other related topics here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
01-24-2006, 12:04 PM
| |||
| |||
I'm looking to outfit a IH mill with ballscrews from homeshopcnc.com and servos from cadcamcadcam.com. I'm going to get the servos with the 2.8:1 reduction. This gives 60 oz continuous, and 500 peak stall at 1000 RPM. I believe this should be sufficient. I also want to drive them with Gecko's, because I believe they are brushed DC servos. I don't think the encoders should have any problems with Mach2 either. If anyone has any experience or comments on these motors and Gecko's, it would be greatly appreciated.  |
|
#3
01-26-2006, 03:43 PM
| |||
| |||
| Here is a link to the servo's. http://www.cadcamcadcam.com/index.as...PROD&ProdID=62 Thanks for any input. |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
| | |
Linear Mode
