Has anyone had any good/bad experiences with RUTEX Drives? - CNCzone.com-The Largest Machinist Community on the net!

Darc · #1 12-14-2005, 06:49 PM

Any advice would be greatly appreciated...................Anyone?

svenakela · #2 12-15-2005, 03:01 AM

They are good!

buscht · #3 12-15-2005, 08:16 AM

Ask ynneb. He uses them and is pretty happy, I think.

ynneb · #4 12-18-2005, 07:36 AM

Yes I use them and think it is a great setup. I especially like the way the motherboard intergrate all the axis cards and the relay card in one. This reduces the amount of wireing needed, and the likelyhood of error too. I strongly suggest you get the motherboard and relay board.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)