API Controls software

[Stevie]

I have 2 DS 3402d-E servo amps 2.5amp 74volt
They have step and direction inputs
I have emailed API many times trying to obtain the software to program these small drives; i can't seem to get their attention
So i'm asking here; anyone got the programming software??

[cbcnc]

Stevie,

API Controls is no longer in business. They have been bought by Danaher Motion. I don't think that Danaher is too much interested in supporting older API equipment.
Have a look here to see if there is anything that you can use:
http://metallicbonds.com/APIControls/
I also have the address for a company that at one time was repairing API equipment. They helped me in the past. I will have to look through my files for the address though. Write me if you are still interested.

Chris Barker
cnebarker at earthlink.net

[Stevie]

Thanks Chris
I'd would have hoped for better support; even if a bigger co did buy them out; at least a reply would be nice