Results 1 to 1 of 1

Thread: yaskawa SGMG-09a2ab

  1. #1
    Registered
    Join Date
    May 2006
    Location
    Canada
    Posts
    11
    Downloads
    0
    Uploads
    0

    yaskawa SGMG-09a2ab

    I am trying to convert my VMC with an old anilam 1400m controller. I looking for a low end controller, as I do all the programming on the computer not at the controller. First question: Is it possible to reuse the motors with another control? Will it work with Mach 3? If not, what other controllers would you recommend?
    The Mill has a 11.2 KWV spindle with 16 ATC. The parts that I will be machining have very lax tolerances ie +- 1/16 . I would ideally like to reuse the motors as the motors and encoder packs appear to be working fine.
    Either way, I am open to advice and embrace opinions.
    Attached Thumbnails Attached Thumbnails yaskawa SGMG-09a2ab-millotor.jpg  


Similar Threads

  1. yaskawa MX 1 alarm 310
    By intertrade in forum Mori Mills
    Replies: 3
    Last Post: 12-14-2010, 10:35 AM
  2. Build Thread- Yaskawa bob for Kanalog
    By oxford in forum General Electronics Discussion
    Replies: 3
    Last Post: 07-13-2010, 10:37 PM
  3. yaskawa
    By outctrl in forum Servo Motors and Drives
    Replies: 0
    Last Post: 09-15-2009, 09:05 PM
  4. Yaskawa help please
    By Arty 3000 in forum Stepper Motors and Drives
    Replies: 1
    Last Post: 02-20-2007, 11:35 AM
  5. yaskawa help please
    By h_2_o in forum Servo Motors and Drives
    Replies: 12
    Last Post: 11-19-2006, 08:01 PM

Posting Permissions


 


About CNCzone.com

    We are the largest and most active discussion forum from DIY CNC Machines to the Cad/Cam software to run them. The site is 100% free to join and use, so join today!

Follow us on

Facebook Dribbble RSS Feed


Search Engine Friendly URLs by vBSEO ©2011, Crawlability, Inc.