three phase driver

[manmardam]

i have Yaskawa servo drive with serial : cacr sr 15 bc
yaskawa PDF
in this manual , i see input voltage is three phase 200~230V
is it possible i run this driver with single phase 200 vlot ?
any diagram ?

thx
Amir

[manmardam]

Nobody ?

[Al_The_Man]

It does not say implicitly that it can be fed from 1 phase, refer to P27 you will see that apart from the input being a three phase bridge, there is the control power taken off the input, on the surface the control power feed could be taken off two of the phases and not off all three.
If this is so, there is a good chance that operating on 1 phase would work, you may have to experiment as to what two inputs will work.
If the input was just the 3 ph bridge then it should be less of a problem, if you have the drives on hand, this can be tested.
Al.