matsuura mc600v accident

[pmesilver]

hi
in real trouble here, we have a matsuura mc600v machine which requires 200 v 3phase supply.unfortunatly the electrician has wired it with 440 volts 3 phase!
DISASTEROUS RESULTS

The spindle drive a Yaskawa 626 mt3 has been damaged!and the tool change invertor destroyed , not sure if axis boards are ok or not?

computer fires up
display is showing error codes
366
112
servo error

error 366 is refering to servos and PG , but not sure if this is because the spindle servo is damaged or if axis boards are damaged?

can it be repaired? are there spares available?

if not is any one interested in a scrap machining centre?



paul

[Cooper]

Hello,

Don't worry, i would like to buy your damaged machining centre Just kidding. By the way, dont worry about your machine, electric boxes always have fuses. If not, only few components are burnt, it can be repaired. But bad news, many service repairmen only know to change the cards with the new one. Insist them to find a solution WITHOUT change. You can easily find the spares if your machine is younger than 10 years, i also hope if ur machine is insured.

[bloke]

Are there any error codes on the spindle and axis drives? They all have breakers if you look up underneath the front cards.

[pmesilver]

hi bloke

the axis boards are ok, all breakers are in and boards show green lights.
the spindle servo is definitely kaput we have learned that a replacement is at least 2K therefore the machine has been for sale on ebay but with little interest.

its all rather sad

paul

[bloke]

Are there any codes on the spindle drive? We have used the same drives and may have info that may help.

[pmesilver]

hi bloke

Unfortunately the servo drive for the spindle is totally dead ,so there is no readout on it at all.

the loading board at the back has obvious damage on it, and the main board we suspect also has damage.

the last time we tried it after replacing a fuse , a capacitor on the load board literally blew appart! a dead short somewhere?

so we are at a loss

paul

[bloke]

Next question, what rating is the drive? is it 11kw?

[pmesilver]

hi bloke

drive is 5.5 kw continuous /7.5 kw peak
7000 rpm spindle

paul

[bloke]

I've had a look, I can find a 3.5k and an 11k but no 7.5k

[cnc_swe]

this was on ebay now but the last day is tomorow. I was intressted but I need photo before I pay £9090 to ship this to Sweden. Last time I so it was 1 bid and start price was £1500 it a nice price if you can repair machinery itself. I have faund same type in Sweden which makes it a lot easier. But when I asked what was wrong, the answer is a some cable connected incorrectly and spindel and tool changer don't work at all.

[Sabrina_B]

Please, help me! I have a mc600v that is giving me a 423 counter error and a 182 sequence error. Does anybody know what is going on with my machine. I don't have the right manual. They shipped the wrong one with it. Thanks