Need Help! Electro-Craft DC Motor - CNCzone.com-The Largest Machinist Community on the net!

nastek · #1 06-23-2010, 03:35 AM

Dear Sirs,
I have a dc servo motor "Electro-craft" that will I use for Mach3 software.
I do not know the specs.
If anybody know the datasheet, please help me.

Thanks
Nastek

sandefuj · #2 06-23-2010, 06:48 AM

It looks like a 728, if so here are the basic's.
Voltage 120v
Max Continuous speed 2700 rpm
Max peak torque 2880 oz-in
Max continuous stall torque 576 oz-in
Max peak current 60 A

nastek · #3 06-23-2010, 10:08 AM

Thank you sir, i will find the match driver for this motor

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Electro-Craft motor with newer drive	Material guy	Servo Motors and Drives	8	06-08-2011 03:16 PM
infor needed on electro-craft E656 motor	steverrino	General Electronics Discussion	4	05-12-2009 02:52 PM
Need Help!- Electro Craft Servo motor	sermys	Servo Motors and Drives	0	04-15-2009 12:57 AM
electro craft sero motor	droj	Servo Motors and Drives	2	04-12-2009 09:43 AM
Electro-Craft/Reliance Electic Motor ???	elalto	General Electronics Discussion	1	08-05-2006 01:42 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)