Results 1 to 3 of 3

Thread: What do you know about this drive??

  1. #1
    Registered
    Join Date
    Mar 2006
    Location
    usa
    Posts
    117
    Downloads
    0
    Uploads
    0

    What do you know about this drive??

    Hello

    I picked up a few of these drives on ebay and now I cannot find any manuals or pinouts so I am dead in the water. The circuit boards inside were made by Minarik per the silkscreen on the boards but Minarik says the design was sold 8 years ago to ACtech/Lenze. It's not listed on their website but the guys at Minarik said they think it was an older version of "simpleservo"??

    If you can help me at all, I would appreciate it very much.

    http://www.allthingsrc.com/drive.jpg

    edited:used on a MultiCAM MG204 router system.
    Last edited by buckeyes1997; 04-23-2010 at 01:09 PM. Reason: new information


  2. #2
    Registered
    Join Date
    Apr 2010
    Location
    usa
    Posts
    1
    Downloads
    0
    Uploads
    0
    Do you have a model number or anything besides the boards inside to id this unit?

    JC Chamberlin
    Precision Electric Inc


  3. #3
    Registered
    Join Date
    Mar 2006
    Location
    usa
    Posts
    117
    Downloads
    0
    Uploads
    0
    Unfortunately I do not have much to go on.

    I have found that one board says Minarik and the others are blank with no model numbers or names. I have found out that it went to a MultiCAM router MG204. The drive seems to be a brushless drive with RS-232. I was told that ACTECH/LENZE owns the design but doesnt use them any more.

    Any ideas?


Similar Threads

  1. Direct Drive Vs Belt Drive for a Mill/Drill Retrofit?
    By pfeist in forum General Metal Working Machines
    Replies: 11
    Last Post: 02-13-2012, 03:12 AM
  2. Clausing Lathe Conversion, direct drive or reduced drive
    By Marty_Escarcega in forum Stepper Motors and Drives
    Replies: 0
    Last Post: 03-16-2010, 11:43 AM
  3. Need Help!- Direct Drive Plasma - Motor/drive/power supply?
    By CPierce18 in forum General Waterjet
    Replies: 1
    Last Post: 02-05-2010, 06:53 PM
  4. Need Help!- Direct Drive Plasma - Motor/drive/power supply?
    By CPierce18 in forum Stepper Motors and Drives
    Replies: 0
    Last Post: 01-29-2010, 02:01 PM
  5. Replies: 3
    Last Post: 07-03-2008, 07:57 PM

Tags for this Thread

Posting Permissions


 


About CNCzone.com

    We are the largest and most active discussion forum from DIY CNC Machines to the Cad/Cam software to run them. The site is 100% free to join and use, so join today!

Follow us on

Facebook Dribbble RSS Feed


Search Engine Friendly URLs by vBSEO ©2011, Crawlability, Inc.