| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Servo Drives Discuss all Rutex servo drives and get direct support! |
| | |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
03-30-2005, 04:14 AM
| |||
| |||
Hi, I want to use the err signal to trigger the z axes brake (no power to the motors---> the brake will hold the head against the gravity) In the manual I can't find anything about the working of the err signal of the R990 board. Please any comments? Frank  |
|
#2
03-30-2005, 06:10 PM
| |||
| |||
| Frank, Please call me at 573 341 1528. I'm not sure I understand what you mean. We can discuss your idea. Tom Eldredge Rutex LLC
__________________ (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Electrostatic shield on torroid | 2muchstuff | General Electronics Discussion | 14 | 05-24-2005 07:57 PM |
| code 86 dr signal off | CBNDude | Mazak, Mitsubishi, Mazatrol | 13 | 03-25-2005 01:08 PM |
| Mach2 PWM freq? | Al_The_Man | Mach Software (ArtSoft software) | 3 | 03-22-2005 02:05 PM |
| Strengthening wireless network signal? | kong | Computers and Networking | 9 | 02-04-2005 11:42 PM |
| Active High/Active Low | Sanghera | General Electronics Discussion | 21 | 11-06-2004 08:47 PM |
| | |
Linear Mode
