| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Servo Drives Discuss all Rutex servo drives and get direct support! |
| | |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
03-20-2005, 12:53 PM
| |||
| |||
 size of drive for enitre unit I am planning on mounting my servo drive in my gantry as all of my motors will be in the gantry and should make wireing simpler. I need to know the dimentions of the 990h setup with the motherboard so i can fing a spot to place it in the gantry. Also if the dimentions of the 2000 series drive are available I would like thoes too as I dont have the drive yet but will be ordering soon and hopefully they may be out by then. Any info on the 2000 series Rutexus? Thanks, Darren    |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Using a large drive on small motor? | murphy625 | General Electronics Discussion | 0 | 03-11-2005 05:23 PM |
| Good DC motor and drive | JRoque | General Electronics Discussion | 11 | 01-02-2005 10:38 PM |
| size of 4th axis drive | converterk | AjaxCNC Control Products | 10 | 06-07-2004 11:01 AM |
| Bolt On Quill Drive Unit | Kookaburra | Bridgeport and Hardinge Mills | 11 | 04-01-2004 12:19 AM |
| What size drive screw? | xairflyer | DIY-CNC Router Table Machines | 1 | 01-04-2004 08:23 PM |
| | |
Linear Mode
