Help to setup Rutex drives - CNCzone.com-The Largest Machinist Community on the net!

Moondog · #1 07-12-2004, 02:33 AM

Received my Rutex drives, motherboard and Limit switches now I need to set them up. I have downloaded all of the docs from Rutex but I am still confused. Are there any docs that show you how to connect in simple terms. I am not electrically minded and looking at the schematics doesn't make sense.

What type of cabinet should I get. On/off switches etc...

In short, I need 'the dummies guide'.. The tuning part I think I can handle.

Any help would be appreciated.

cheers

Frans

svenakela · #2 07-12-2004, 03:55 AM

Send a mail to Rutex, he's very helpful. support@rutex.com

Cheers,
Sven

Moondog · #3 07-12-2004, 04:06 AM

Thanks svenakela

Just sent an email to him. He has been so helpful so far I didn't really want to bother him again..

ynneb · #4 07-12-2004, 05:26 AM

Moondog, ring me and I will go through it with you.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
2000 series Rutex drives	rutexus	Servo Drives	19	04-03-2007 05:00 PM
Inductors with Rutex Drives	MMT	Servo Drives	4	03-13-2005 05:59 PM
problems with tuning of Rutex drives	FrankdB	Servo Drives	2	06-21-2004 04:16 AM
Rutex Drives	mikburts	Servo Drives	0	05-01-2004 08:55 AM
Rutex Drives	mikburts	Servo Drives	4	04-10-2004 08:16 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)