Does anyone have any information on the subject motor encoder. They have a really stange setup using an op amp. I have tried to figure out the wiring but m starting to think that there are two voltages required. One for the LEd and the other for the Op amp.
If anyone hase the information on this encoder I would appreciate it.
Wire colors are
Red
Green
White
Yellow
Black
shield
Dan
As a last resort you could do some reverse-engineering and if you can identify the IC's, then obtain their normal voltage from a Spec sheet, by resistance check from IC power and common, the power leads can be identified, quite possible black and red are power, with green,white,yellow the ABZ outputs, as long as it is not a serial output type.
The ABZ can be identified with a simple voltmeter method, turning the shaft as slow as possible.
Al.
Last edited by Al_The_Man; 08-09-2011 at 03:41 PM.
CNC, Mechatronics Integration and Custom Machine Design (Skype Avail).
“Logic will get you from A to B. Imagination will take you everywhere.”
Albert E.
Posting Permissions
LinkBack URL
About LinkBacks
