- Advice Needed servo drives and controller software
-
Member
Advice Needed servo drives and controller software
I bought a going Morbedelli Auther as it was a lot cheaper than building a new one.
It runs using Yaskawa ac servo drives with very impressive traverse speeds.
My idea was to retro fit it with Deskcnc, as this is what I have and I am used to.
So far I have it up and running with the kind help from users on the forum.
All my experience is around steppers I'm new to servos.
My question is how do I get those same traverse speeds, it runs like it's got stepper motors, is Mach3 better or is this as good as it gets?
I was surprised at the different steps per millimetre on the 3 axis X was about 250 Y 900 Z 1100 the differences between encoders and ball screws.
Paul
Similar Threads:
-
- Advice Needed servo drives and controller software
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules