DENSO 4 axis robot servo


Results 1 to 2 of 2

Thread: DENSO 4 axis robot servo

  1. #1
    Registered
    Join Date
    Feb 2017
    Location
    Australia
    Posts
    1
    Downloads
    0
    Uploads
    0

    Default DENSO 4 axis robot servo

    Hi
    New here today so thanks in advance for any help.
    I have acquired a Denso 4 axis robot with no controller that I am planning to use to pick and place parts in a spot welding operation. I was going to use the MACH 3 controller system to operate this system. My question is how do i find out the specs - volts , amps and the like, for the servo drives so i can build the controller?

    Similar Threads:


  2. #2
    Registered James Newton's Avatar
    Join Date
    May 2005
    Location
    USA
    Posts
    1397
    Downloads
    0
    Uploads
    0

    Default Re: DENSO 4 axis robot servo

    If your motors where steppers, then this page would be the answer:
    techref.massmind.org/techref/io/stepper/estimate.htm
    but as this is for a servo system, that will give you the watts, but the selection of the drive is slightly different. You should check on the gecko-driver page:
    geckodrive.com/support/choosing-a-drive.html

    James hosts the single best wiki page about motors for CNC hobbyists on the net:
    http://techref.massmind.org/techref/io/motors.htm Disagree? Tell him what's missing! ,o)


Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

DENSO 4 axis robot servo

DENSO 4 axis robot servo