Japan servo motor DS64BE40-2 Encoder wiring

Results 1 to 2 of 2

Thread: Japan servo motor DS64BE40-2 Encoder wiring

  1. #1
    Member
    Join Date
    Feb 2008
    Location
    USA
    Posts
    243
    Downloads
    0
    Uploads
    0

    Default Japan servo motor DS64BE40-2 Encoder wiring

    Does anyone have any information on the subject motor encoder. They have a really stange setup using an op amp. I have tried to figure out the wiring but m starting to think that there are two voltages required. One for the LEd and the other for the Op amp.
    If anyone hase the information on this encoder I would appreciate it.
    Wire colors are
    Red
    Green
    White
    Yellow
    Black
    shield
    Dan

    Similar Threads:


  2. #2
    Community Moderator Al_The_Man's Avatar
    Join Date
    Dec 2003
    Location
    Canada
    Posts
    24216
    Downloads
    0
    Uploads
    0

    Default

    As a last resort you could do some reverse-engineering and if you can identify the IC's, then obtain their normal voltage from a Spec sheet, by resistance check from IC power and common, the power leads can be identified, quite possible black and red are power, with green,white,yellow the ABZ outputs, as long as it is not a serial output type.
    The ABZ can be identified with a simple voltmeter method, turning the shaft as slow as possible.
    Al.

    Last edited by Al_The_Man; 08-09-2011 at 03:41 PM.
    CNC, Mechatronics Integration and Custom Machine Design

    “Logic will get you from A to B. Imagination will take you everywhere.”
    Albert E.


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

Japan servo motor DS64BE40-2 Encoder wiring

Japan servo motor DS64BE40-2 Encoder wiring