AlphaCAM Post Needed (Licom)

[NardisAmps]

Hello,

Does anyone have or know of an AlphaCAM post thats available for Mach 2?? A friend of mine designs in AlphaCAM, but I'm running a small router w/ Mach 2. Can these mesh?

Thanks!
Nardis

[ShodaPete]

Nardis,
I've written quite a few Alphacam posts. If you'd like to discuss your machine and post needs, call Pete at 920 434-3345.

[tantan]

Originally Posted by ShodaPete Nardis, I've written quite a few Alphacam posts. If you'd like to discuss your machine and post needs, call Pete at 920 434-3345.

hi, i am looking for an alphacam postprocessor for mach3 (turning) als well. did you find any?

thanks

antoine
the netherlands

[Artecnc]

Originally Posted by ShodaPete Nardis, I've written quite a few Alphacam posts. If you'd like to discuss your machine and post needs, call Pete at 920 434-3345.

Hi

I´m working a Syil mill 4 plus, this is a new machine in my shop, and I nead a post to mach 3, because I´m used Alphacam in another router, you can see my site, www.artecnc.com.ar, would you help me ?, I´m in Argentina, my mail is antonio@artecnc.com.ar, in this moments I´m outside off my shop, and I retun in 10 days, thank in advace
Best regards
Antonio

[dung_ninhbinh]

I know AlphaCAM
if you like a post, i can write the post for you. Please send some codes on your machine to me
my e-mail dungvannguyen24052011@gmail.com
all free for you

[Dan911]

Originally Posted by NardisAmps Does anyone have or know of an AlphaCAM post thats available for Mach 2?? Thanks! Nardis

inches or mm?