MascerCam9 LATHE Post for Mach3

[chris59]

Hi yall,

I finally finished testing it. Enjoy it, and let me know how it works for you.

NOTES:
======
1. Output is in the RADIUS mode, to follow MACH3 wizards convention;
2. Axis polarity is set to be same as in MACH3;
3. Canned threading, G76 is NOT supported. Use Longhand or Alternating methods in MasterCam Threading menu (G32 based).
4. G28 references are disabled - use MACH3 Macros instead when changing tools. To re-enable change line:
no_g28g50onTC : 1 to
no_g28g50onTC : 0

Get it from:

http://www.novalab.org/mach3/index.htm

Regards,

Chris

[asuratman]

Hi Chris,
I can not get that post from your link. Please let me know how. Thanks. Aristo.

[asuratman]

Thanks Chris. I found from your other website. Aristo.