Post Processor for Pro/Engineer? - CNCzone.com-The Largest Machinist Community on the net!

mgamber · #1 10-28-2005, 02:00 PM

Anyone have or know of a post processor for Pro/Engineer (Pro/NC)? If not which one of the included ones can I use?

TeQ · #2 11-02-2005, 01:35 PM

you have to know what type of controller that you are using...say if u r using Fanuc, there's several type of fanuc (OM, 16i, 18i, 21i, etc) and once u provided that, ppl can help you out what type of pp is the most suitable one.

mgamber · #3 11-02-2005, 01:38 PM

Originally Posted by TeQ

you have to know what type of controller that you are using...say if u r using Fanuc, there's several type of fanuc (OM, 16i, 18i, 21i, etc) and once u provided that, ppl can help you out what type of pp is the most suitable one.

Ummm... Mach3? Since this is the Mach software forum...

markhas · #4 03-07-2007, 09:06 AM

mgamber,
Did you have any luck getting a Pro/E to Mach postprocessor? If so, could you please share it? I am looking for it too.
Thanks,
Mark

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)