OneCNC Mach 3 Post

[TPPJR]

What happened to the Mach 3 OneCNC post? I found it the other day on here somewhere but now can't seem to find it???

Thanks,

Thomas

[PoppaBear10]

there is a mach 3 post under the "Post" thread on the OneCNC forum. I know, I put it there my self.

P.

[TPPJR]

That is where I thought it was too and am pretty sure it was yours that I saw but still can't find it. You sure it is still there?

Thomas

[PoppaBear10]

Yes, it is about the 3rd or so post down, BUT, If you would email me at my Army puke address. I will email you the PP directly to you, I will even remove the arthor and other stuff, to make it as generic as possible.
my email is: gordon.shafer@us.army.mil

later, and btw, if you need I also made a post that works with Mach 3 Lathe and OneCNC XR Lathe

scott

[TPPJR]

Scott,

Thanks for your help. I am so aggravated right now I can't see straight. I STILL can't find it. I don't just want the pp, I want to follow the thread. I remember there was talk about NC setup.

I have looked in OneCNC main, XR and under the main post processor file.


What is going on????

Thomas

[TPPJR]

I found what I was looking for. It was under the onecnc forum. Yea, I know that is what you said but I thought you meant the onecnc forum under cnczone!!!! That is why I could not find what I was looking for. Not the onecnc standalone support forum.

Thomas

[CATCH22]

I Am Looking For A Mach3 Lathe Post And A Mach3 Mill Post For Mastercam If You Think Yours Would Work For Me I Would Really Like To Try It, Poppabear10. Thanks Mike.

[PoppaBear10]

Hey Mike,

The Post I wrote (fixed), only work with the OneCNC Mill XR and XR2, and OneCNC XR Lathe.

I have never used master cam, so, would dought very much these two CAM programs would work the same. The Post for OneCNC is very much so, OneCNC specific.

Sorry, wish I could have helped you,

Scott

[CATCH22]

Thanks Anyway Scott, I Am Just Getting Started At This So I Am A Little Green. Thanks Mike