| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Rutex Products Sub-Forums: Flame Cut Products, Servo Drives, Software Products |
| | |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
10-30-2007, 07:02 AM
| |||
| |||
In the document i insert pictures with messages i get when i use RT990H (DOS) and Rutex Tuner(Windows) I am not useing rutex motheboard but i wire it direct to parallel port . What to do?    |
|
#2
11-01-2007, 08:40 PM
| |||
| |||
| So, there must be a signal (wire) that is used to indicate that a Rutex driver is connected.....or is the software interrogating the driver and it's responding , but your communication back to the computer is mis-wired? Look at the Rutex documentation....look for a driver sense line... |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Trouble with Yaskawa Drive & Servo | curtisturner | Servo Motors and Drives | 4 | 04-28-2011 01:57 AM |
| Testing Drive Boards | bob a job | General Electronics Discussion | 1 | 11-22-2007 05:07 PM |
| g320 servo drive initial testing - problems and questions | fbmstar | Gecko Drives | 2 | 04-09-2007 10:45 PM |
| Testing for drive enable? | murphy625 | CamSoft Products | 5 | 04-06-2005 05:04 PM |
| R990h | dpaulson | Software Products | 2 | 02-22-2005 10:35 AM |
| | |
trouble with configure and testing R990H servo drive 
Linear Mode
