- RhinoCAM High-Speed Machining spits out junk
-
Registered
RhinoCAM High-Speed Machining spits out junk
I ran an HSM pocketing pass on an absurdly simple piece of geometry (two parallel curves capped on the end) and it kept failing to load on my controller. Eventually tracked it down to the fact that RhinoCAM was actually spitting out zero diameter circles. Anybody else have a horrible time with their HSM routines?
Similar Threads:
-
- RhinoCAM High-Speed Machining spits out junk
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules