- 4th axis jewelry carving
-
Registered
4th axis jewelry carving
I'm trying to generate a toolpath to make a ring on my rotary 4th axis.
Roughing with a 1/8" bit is fine but the problem is that Its taking way too long to generate the finishing path for the bits that i use.
I have 2 bits that i want to use for finishing. 0.3mm endmill and a 1/8" veemill / v-bit.
Could someone help me get around this problem?
Similar Threads:
-
-
Registered
Re: 4th axis jewelry carving
After a week of continuous research I found that jewelers use .004 stepover when using a tapered bit. I've successfully milled a ring with those specs but it took about 5hours to calculate the toolpath. Is it normal for Rhinocam to take that long to calculate the toolpath?
- 4th axis jewelry carving
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules