RhinoCAM & DSP RZNC0501

[sos13]

Has anyone used RhinoCAM with the DSP Controller RZNC0501?

I have been using Vectric and selected G code MM. *tap file but in RhinoCAM I need the correct post processor and can't seem find the right one.

Anyone have any suggestions??

Thanks

[pointcloud]

Email mecsoft support they'll make it happen

[danielcoyle]

Sos
I am doing exactly the same thing right now with a new router. Trying to get the right post processor for my dsp. Did you figure it out or did they have to make you one?