I have just acquired
Akira-Seiki Performa V2.5 XP milling center,
and it came without a programming manual.
Does anybody have a RhinoCAM post-processor for this machine?
I'm looking for any leads I can get.
They've had a lot of experience configuring their post-processors for all sorts of machines, and if they don't have a post for this one already, they'll probably be able to configure one specially for you. There's normally no charge for this, if you're a registered user.
Unfortunately you'll have to wait until Tuesday to ask them about it, since this is a 3-day holiday weekend in the US (Independence Day).
ComputerSculpture.com — Home Page for Discount Hardware & Software