DIPTrace DXF to Rhino problem

[Rhodan]

I have a circuit DXF exported from DIPTrace that works fine in both Visual Mill demo and the ONECNC demo but, it is completely garbled when loaded into Rhino 3 demo.

Would anyone know if this is just a problem with the demo or is the real version of Rhino 3 the same? If so, is V4 any better at the DXF import?

I should be receiving Rhino and VM tomorrow (UPS phoned today!).

[chmillman]

If it's not too big or secret and you can attach it, it would be good to see what's going on. --ch

[Rhodan]

I just tried it again with my registered Rhino and registered DIPTrace - works like a charm. Must be just a demo issue in either Rhino or DIPTrace.