Please send SolidWorks files to firstname.lastname@example.org
Just submitted 17 parts to FirstCut.com. They are probably going to be very expensive.
There are actually 18 parts, one is turned, which they can't do.
Debur/Bead-blast/Tumbler deburring (almost any approach will work for these parts)
Work directly from SolidWorks files (I hate doing prints unless I absolutely have to).
Tolerances are not tight.
Several of the parts consist of drilling and tapping flat stock after cutting to size/shape.
One of the parts is a 16 inch long picatinny rail profile with a few holes drilled/tapped. No recoil slots.
There are a couple of parts that have a little more machining work.
One round steel shaft (drill stock) cut to length, grooved for a retaining ring, chamfered and one flat cut for setscrew.
Another round part starts as a 1 inch nominal aluminum rod, cut to 6 in length, drill-tap both ends, chamfer.
The point is that all the parts are pretty simple.
I need to prototype this design and then look into making a small run (10 to 25 sets). Following that we'd be looking at 100 to 1,000 sets at a time. Not sure yet.
PM if interested.
Could you please send me the files to look at (email@example.com).
we be interested in quoting this package to.
Thanks for all the replies (except for the clueless Chinese dude).
Sending files to those interested.
Please send me the files if you have not already been satisfied with the prices you are being quoted.
Manufacturers of ballistic resistant, explosion resistant and impact resistant materials
PM Sent. Thanks
Please send SolidWorks files to: firstname.lastname@example.org
We would be interested in quoting this.