This is Turn-Key Viper X Demo air cutting a circle at 6000 mm.
More information can be found at http://www.precisioncncrouter.com
Only thing about measuring off top off profiles, is that they are not perfectly FLAT. Try staying close to corner other than right across top of profile.
Works nice with small motors.
XZero cnc
This is Turn-Key Viper X Demo air cutting a circle at 6000 mm.
More information can be found at http://www.precisioncncrouter.com
More progress on the Predator. Final wiring is being done now with a C10 and C6 board, controllers and power supply are completed.
George, do you think I should add the backing bars?
Adding mass to anything will make it stronger and less vibration. With cutting aluminum it makes big deference. With lager Tekno spindle would help a lot and could take far deeper cuts. Having the new 13 inch travel Z axis,bar would be needed
XZero cnc
Hi, George:
The Distance between the holes are the same for both? ... would then be a full thread (side to side).
What VFD did you use?
Checkout the thread below. I am using the same VFD.
http://www.cnczone.com/forums/xzero_...pindle_c6.html