| | |
it doesnt seem that i can import .prt into MC version 8... What version are u using? how did u do that? im sorry if this question seems so unprofessional...but i have never done any solid in MC..please advise
Well in version 8 it was a chook add-on form Cadem-e then in V9 it was an added cost but was bulit into the system and the same with the version I run now being Mastercam-X it is built into the system.
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Cadcam
Owner, contract Programming and Consultant , Mastercam Instructor and on line trainer at www.eapprentice.net
Some tips: http://www.youtube.com/PrecisionProgramming
Posting Permissions
| | |
LinkBack URL
About LinkBacks
