G-Post for Integrex 1060 - CNCzone.com-The Largest Machinist Community on the net!

massud · #1 03-12-2007, 07:13 AM

I am not able to configure in the right way the G-post for Mazak Integrex 1060.
Could someone tell me if it is available a download site to get one copy of it??
I would use it under Pro/Wildfire 2.0 or 3.0.

Thanks in advance
Massud

585integrex1 · #2 03-12-2007, 08:59 AM

i am not aware of any free posts out there, but if you find one i would like to know too.

JonasC · #3 04-27-2007, 04:50 AM

If you have a active maintenance agreement with PTC you can download a few free Postprocessors from their websites here: http://www.ptc.com/cs/cs_23/howto/ncgp4903/ncgp4903.htm
Requires a password though.

Theese are often more easy to modify rather than writing one from scratch.
Other than that I think you will have to pay up to get one custom made, if you dont find a kind sould that has the same setup as you.

Best regards, Jonas

Motoomunda · #4 12-08-2009, 10:18 AM

Also need post processor file for Mazak 1060 and Alphacam v7

Anybody have this file please?

Thanks in advance.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Mazak Integrex 200 III St ISO/EIA	maramb	Mazak, Mitsubishi, Mazatrol	19	11-28-2007 03:41 PM
Integrex IV help	Demon440	Mazak, Mitsubishi, Mazatrol	8	02-19-2007 02:21 PM
integrex 50 YB ISO Programming	Batman	G-Code Programing	3	12-12-2006 06:47 PM
num 1060 or the like	sc_crasher	Fanuc	3	01-11-2006 08:11 PM
Procam Ii Post For Mazak Integrex	BROCD	General CAM Discussion	9	02-17-2004 12:09 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)