Pro/nc can't post

[unterhaus]

we're just starting with Pro/E and there are some parts we'd like to have made. I get all the way to where I want to post, and it fails. The error message is less than informative. Is there any way to get any more information about why it fails to post?
I was trying to use the Haas VF1 post that came with the software.

[fpworks]

Are you able to launch the option file generator?

What operating system?

[unterhaus]

Sorry it took so long to get back to this post.
Yes, we can open the option file generator. We are using windows XP.

[lakeside]

For what they charge for Pro-E I would be on the phone to them long before looking elsewhere for help but this is a good place to look for help

[unterhaus]

We have the academic version, which is fully functional but cheap. Thus support is not part of the deal.

[lakeside]

check to make sure the path to the post is set-up right on the software set-up pages also sometime if you just call with a simple question they will still answer but they would not write a post for you Pro-e is a pretty good about that they are one of the better software company

[cncwhiz]

Unterhaus,
What are the issues you are seeing on the screen? There a few ways that this can be an issue with. I would say that if you can open gpost then most likely the problem is in your config pro. Feed me some more info and we can get it going. I also might have a post or two for a haus. We run pro for modeling, drawings, assemblies and manufacturing and dumped maintenance last year. There is sites and people out there that can get you going.