Hi.
I have a minor problem.
I use Solidedge2d v20, because i am familiar with it.
I use e.g. the font called sesimplex ( single line font ).
Then i use Prodge to explode the text in to lines.
Then i use lazycam to define my my graving depth.
Rapid hight e.g 5mm, graving hight 3mm. The convert it to g-code.
Then i line my cnc up, and start. Then i experience that with the letter
" A " the z axes drops below 3mm graving hight, down to 0mm, but with other
letters it is ok..
What happens??? Is it Progdecad that converts wrong or ?????



Regards John Hansen