GE 1050 mark century N17 error - CNCzone.com-The Largest Machinist Community on the net!

eastpaman · #1 01-20-2009, 10:23 PM

I have problem with loading my program in the 1050.I have tried shorting my cable,a different computer to send it I still get a N17 error-Parity flag fails to clear

WGoyer · #2 01-20-2009, 11:52 PM

Do you know which model it is: T, MC, H, HL, MCL? What machine is it on?

Warren

www.uptimecorp.com

eastpaman · #3 01-21-2009, 06:14 AM

1050H on a strippit

WGoyer · #4 01-21-2009, 08:42 AM

I guess I would get a little RS-232 tester to put in the line and watch the lights. Punching something out would be a good first test.

Assuming that nothing has changed on the computer end (baudrate, stop bits, parity etc.) it sounds like it might be a hardware problem.

It has been a long time since I worked on an H, but I seem to remember that the cable jumpers select the baudrate. If so, it might be time to open up the connector and check for broken jumpers.

Warren

www.uptimecorp.com

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
GE mark century 2000 drip feeding	ncmas	Machine Problems, Solutions , Wireless DNC, serial port	5	10-11-2011 06:56 AM
Mark Century 2000 Dnc Problem	ozgurm	Machine Problems, Solutions , Wireless DNC, serial port	5	02-17-2009 11:22 PM
1050 MC Reversal Error Comp.	smts	General CNC (Mill and Lathe) Control Software (NC)	0	10-28-2008 03:34 PM
Code generator for Monarch VMC75/Mark Century 2000	grweldon	EdgeCam	0	03-31-2008 10:55 AM
Century 82050 Question	meerkatguy	CNC Plasma and Waterjet Machines	4	11-15-2006 02:41 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)