Professional use caliper - CNCzone.com-The Largest Machinist Community on the net!

hkrok · #1 11-20-2008, 07:22 AM

The sliding action is nice and smooth, there's no grittiness or binding. The repeatability is consistent, you can open and close the jaws a number of times and they will reliably return to zero. The body parts have been machined clean and tight so there is virtually no lateral play in the jaws. The display is clear and the segments are all equal contrast

www.roktools.com

hkrok · #2 11-20-2008, 07:29 AM

hkrok · #3 11-20-2008, 07:34 AM

billystein · #4 11-20-2008, 01:07 PM

who is distributor?

hkrok · #5 11-21-2008, 07:47 AM

Originally Posted by billystein

who is distributor?

Where are you . tell me your location

hkrok · #6 11-23-2008, 12:12 AM

hkrok · #7 11-23-2008, 12:14 AM

hkrok · #8 12-03-2008, 10:20 AM

hkrok · #9 12-05-2008, 09:29 AM

The sliding action is nice and smooth, there's no grittiness or binding. The repeatability is consistent, you can open and close the jaws a number of times and they will reliably return to zero. The body parts have been machined clean and tight so there is virtually no lateral play in the jaws.

hkrok · #10 12-08-2008, 06:58 AM

www.roktools.com

hkrok · #11 12-17-2008, 03:22 AM

Our calipers are not jerry-built.

Not every Chinese company make bad quality products.

hkrok · #12 01-01-2009, 09:52 AM

Thanks for your support

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Best Digital Caliper	Limited660	Calibration & Measurement	16	04-20-2010 08:51 PM
Digital caliper sales	hkrok	Product Announcements & Manufacturer News	51	06-04-2008 05:06 AM
Anyone own a waterproof caliper	carbidecraters	Calibration & Measurement	11	10-24-2006 05:46 PM
where to get a 36" digital caliper	Runner4404spd	General Metalwork Discussion	2	04-06-2006 06:28 PM
DRO on HF 8x12, Caliper and Magnets?	sanddrag	Mini Lathe	5	03-20-2006 07:19 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)