new machine just completed

[larryy1022]

Hi all,


Here share some pictures of a newly built table cutter.
Check follow pictures.

any comment, please advise freely.
Thanks
larry

[jtlapp]

First rate!

I take it that the roller bearings and ramps are for opening the exhauste dampers under the torch as it travel along the cut.

[larryy1022]

Thanks, you're right.
But we are the CNC system and THC supplier, the table manufacturer is our customer-)


By the way, this table manufacturer is very itnerested in exporting their machine, may I ask, how much would a table like this (around 1.5*3m cutting area) cost in US?

If with 3 pcs servo, Mitsubishi E series ( 400W on x axis, 750W on y1 and y2), then how much ?

very curious about it
Tks
Larry

[lalitsharma2176]

Slab Milling Cutters Find complete details about Cutting Tools, from Maxwell Tools Co. You may also find other Cutting Tools, products or Other Tools

[larryy1022]

follow is the I/O expanding control card used in this machine, it supports 4 torches.

And suitable for all MicroEDGE, EDGE, burney controllers.