Hi,

This looks to be the closest section on this forum to what I have ordered. Its an Aeronaut unit. Not sure if there is anyone around here that is familiar with them.

Its a cutter/plotter for industrial fabrics. Basically the same setup as a unit setup for vinyl guess. Basic X-Y table with air actuated Z to operate the pen/cutter.

When it arrives and the tech sets iit up, can post up some pics if there are interested folk.

My next issue is to find a method to digitize my physical stencils, so they can be reproduced in exact scale on the new table. Suggestions here, especially if they dont cost a silly amount, are most welcome.

jatt

Similar Threads: