Sides done and bottom square migd in. It took awhile to square it up by myself but it is dead on. The 2x3 you see clamped is to hold the side upright and to help keep them from warping in or out ward. What is not in the picture was the big ass Machinist angle plate that was clamped in the mix also.
Some stuff most of you have already seen.. If I get a free moment this afternoon I will try and post my Table drawings...
V-Rail and rack along with pulleys and Ugraded Z-axis
The z-axis is a finer acme 5 turns to and inch vs. 10 turns