same problem .. anybody plz help with 5 axis post processor for Mach3 ..
my mail: Mirvaysfirstname.lastname@example.org
Hi to all
I need a general(Fanuc,Mach3,...) 5 axis post processor for Powermill software by PMPOTS processor.
Please help me and sent a 5 axis post processor to below emai:
the postprocessors are adapted from the characteristics of the machine you own so you cant use any postprocessor it should have the same options as your machine.
what are the roatations on yours machine:
1. table - table (bed type)
2. table - head
3. head - head
and there are the distances from the table to the center of the rotation,
etc etc ...
I have been adapting some postprocessors for 5axis mill but for the DUCTPOST my guess that it is similar for the PMPOST...
same kinematic as here 5 Axis Gantry Router i don't know what type is this ... i think it's head - head
Last edited by Mirvays; 07-08-2011 at 12:41 AM.
Please contact to me,i have post 4 , 5 axis. sure,tested ok.
Viet nam, +84903355091.
You can pay a some money for that.thank you so much
This kinematic head-head, but for best result you need MTD files.
Hello, I'm looking Mach3 5axis BC postprocessort Powermill