Need Help!- Canned drill cycle code output

[winchdoc]

Hi there,
I have an Acramatic 900 control that wants the canned drill cycles (G81,G82,G84, etc) to have the Z depth expressed as an increment from the R plane.

Example:
What I want:
G81 Z-10000 R3000 F250; This will make a drill depth of Z-7000.

What I get:
G81 Z-7000 R3000 F250; This only goes 4000 deep.


In MCAM X3,
Where in the post do get it to output the Z as the increment?
I've tried things in the tool paramaters, but I beleive it is something simple in the post.

Thanks,
Doug