Postprocessor for bridgeport ez-trak needed

[binde16]

I am looking for a postprocessor for a bridgeport ez-trak for either mastercam v9 or X. if anyone has one and is willing to share it it would be greatly appreciated.

Thanks
Mike

[littlebrewman]

did you try to contact your mastercam reseller yet?

[binde16]

We primarily use NX here so our reseller doenst want to give me a post for nothing and I dont want to pay for a post that I am going to use once for a home project.

[Mike Mattera]

Well there you go... Most people who take the time to write a post, would like to receive a small token for their time and effort. I'll bet you didn't get your machine fro free.

Mike

[Mike Mattera]

Let me ask you something, Did you read the section about "Asking for a post", before asking for a post.

There's a big difference between "give me a free post" and "I need help writing/customizing my post". I need some parts machined. Can you machine them for free for me?

This is a place where people come to ask for help and other try to help them.

BTW: Yes I do have a post for your machine/control.

Mike Mattera

[binde16]

I actually did the machine for free it is the company I work for. I understand people spend much time writing post for machines and they would like to be compensated. But I am only looking to make one part to brush up on my programming since I havent done it in a few years and cant justify the 1000 my reseller wants for the post. My compnay has the post for the machine in Gibbs and NX but I dont know either of those CAM softwares.