Need Help!- modifiy my post

[joehernandez]

i have a post for master cam it work fine expect the fact it doesnt use the mutli drill now i been using for a while and i dont know if its the post or the program that the problem

[psychomill]

elaborate on 'multi drill' ....

[Superman]

What version of Mastercam ?
What machine is the post for ?
What post was customised for you ?

Put up some code from mastercam
put up the same code that has been modified, run in the machine and proved OK

[joehernandez]

What version of Mastercam ? mastercam x4
What machine is the post for ?shoda ncw- 516 with a fanuc 15-m
What post was customised for you ? i can send u a copy of my post

[joehernandez]

elaborate on 'multi drill' .... my machine has a multi drill head but u doesnt use the head for drill it rather grab one drill bit and drill one hole at a time

[psychomill]

By 'multi drill head' are you referring to a Block Drill? (A tool that has more than one drill on a single tool for a single spindle)
Or.....
the fact that you have more than one spindle and want to drill with more than one spindle simultaneously?

[Superman]

Something like this

The video starts off drilling

[psychomill]

I do happen to know what the machine is... But the machine is configurable. You could buy it as a single spindle all the way up to 6 on this one as I recall.... Hence my question....

[joehernandez]

psychomill ur right it does work both way and i didnt notice but yes it is the block drill im talking about it has 17 spindle on it 11 in x and 6 in y u can say 7 cause u can use the center spindle twice

[psychomill]

Center spindle twice... ??

Anyway, just to be clear... these are known as block drills...



Is something like this is what you're talking about?

I'm also thinking you only have a code problem. You're trying to use a specific tool but the program isn't calling for it? If that's the case, it's not the machine or CAM problem. The problem would be is that you're probably not using the correct T code for that tool.